Set your Crush It to match the stage time, and when the RO starts his timer, start yours simultaneously. Visually (and audibly) monitor the remaining time in your run, allowing you to gauge when to speed up or slow down. Remove the unknown with the MDT Crush It - Stage Timer.
Ready to use out-of-the-box for a preset 2-minute stage, or use Custom Mode to fully customize every aspect of your timer; time, various alert points throughout, tone type, volume, starting tones, and ending tones. Also choose between graphics mode, or digits mode to change how your time is displayed.
WATCH FULL CUSTOMIZATION BREAKDOWN BELOW
Learn how to use your time efficiently and see where you can speed up. Use the stopwatch mode to see how long you’re taking at any point during a stage.
Choose when the timer will beep, what the beep sounds like, how loud each beep is, and how many times it will beep each time, letting you know exactly how much time you have left without even having to look at it.
Mount on any section of Picatinny rail with the included MV3 Inverted 90 Mount so that it’s always in view and easily accessible.
RIFLE MOUNTED FOR EASY ACCESS
AUTO POWER OFF TO INCREASE BATTERY LIFE
VISIBLE IN ALL LIGHTING CONDITIONS
WEATHER RESISTANT
MOUNT IN ANY ORIENTATION
CONTROL VOLUME, INTERVAL, TIMING, & TONE
SILENT MODE FOR VISUALS ONLY
BASIC MODE READY TO USE OUT-OF-THE-BOX
CUSTOM MODE FOR EXTENSIVE CUSTOMIZATION
STOPWATCH MODE FOR TRAINING & STAGE SETUP
GRAPHICS & DIGITS MODES
SAVES ALL CUSTOMIZATIONS
COMPATIBLE WITH 2.5MM PRESSURE SWITCH
LASTS FOR 200 2-MINUTE STAGES ON AVERAGE
3 TONE OPTIONS FOR OPTIMAL HEARING & ALERT POINTS
Cosmetic Black Anodized
6061 Aluminum
Stainless Steel Hardware
3 oz
2.625” x 1.35” x 2.85”
CR1/3N
MDT CRUSH IT - STAGE TIMER
MDT LRA MV3 INVERTED 90 MOUNT
CR1/3N BATTERY
(PRE-INSTALLED)
1/16" HEX KEY
3/32" HEX KEY
